configuring traffic policing and shaping per vlan on ME3400E switch with MetroIPAccess image
How do I configure per vlan traffic policing and shaping per vlan on an ME3400E switch with MetroIP Access image?
I tried configuring a policy-map, but that can't be assigned to a virtual interface.
I have an ME3400E and currently have a router that is managing the bandwidth for one of our customers, I wanted to remove the router and configure the ME3400E to do the routing since it is a layer 3 switch, but I can't figure out how to limit the bandwidth to 15MB for vlan 301. We have another vlan that uses the remainder (85MB) of internet access.
How can I configure the ME3400E to limit both ingress and egress bandwidth to 15MB for a specific vlan?
This is what I tried:
ME1(config-pmap-c)#police cir 15000000
ME1(config-pmap-c)#int vlan 301
ME1(config-if)#service-policy input 15MEG
Configuration failed. Policymap is not supported on virtual interfaces
Most of our ports are access ports and so I can configure the bandwidth management to the physical interface, but the port for our customers that want internet access is a trunk port and I need to be able to limit the bandwidth per vlan (so if customer a (vlan 101) pays for 10MB I can limit them to 10MB and if customer b (vlan 202) pays for 20MB, I can limit their vlan to 20MB
Any help would be greatly appreciated! Thanks in advance
configuring traffic policing and shaping per vlan on ME3400E swi
I'm not sure I understand your example. Say I have one customer - VLAN 301 - that is paying for 15MB of internet access and another customer - VLAN 300 - that is paying for 10MB of internet access, and they share port g0/11 - which is configured as a trunk port and allows VLANs 301 and 300. How would I configure the switch to make sure each customer gets the bandwidth they pay for, but only what they pay for. We are not using class of service at all. We just want to be able to rate limit (traffic policing and shaping) the traffic per customer (VLAN).
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...