Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

EoMPLS with no P router(s)

Pls help clarify the following things:

1. Can I do an EoMPLS psedowire b/w two directed PE routers? I think of PHP behavior, but we can disable PHP!!

2. Pls see the topo

Agg using 7609, sip400 with 2ge uplink, ws.6724.sfp downlink

n.PE using 7609 also, sip600 with 2x10ge for corelink, ws.6724.sfp downlink, sip600 10x1G to BRAS (not shown)

'Cause sip400 doesn't support VPLS, so we intend to deploy E-LAN (EMS) service by lauching EoMPLS from Agg, terminate at n.PE & start VFI fullmesh from here to other n.PEs.

Can I do this? If yes, how can I do xconnect command on n.PE?

Really need yr help & tks!

1 REPLY

Re: EoMPLS with no P router(s)

You can do Eompls without a P device between 2 back to back PE's.

You can configure the xconnect on an SVI interface for the SP vlan.

HTH-Cheers,

Swaroop

260
Views
0
Helpful
1
Replies
CreatePlease to create content