I am trying to do etherchannel between two ports of ME3600 and two ports of Cisco Switch 3400 with either Pagp or LACP. If the ports are with a simple configuration (trunk ports) the etherchannel is up and running properly. But when i apply a simple service instance at port-channel at ME3600, the etherchannel doesnt work properly.
But when the etherchannel is configured with the MODE ON everything is Ok. Is it possible to do evc on port-channel (Pagp/Lacp)?
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...