I have ethernet cfm configured on two Cisco 7609s and two UP MEPs configured under xconnect PW MPLS on the same domain, level and service MA so they became CFM peers.
I notice that after removing and re-configuring olny one UP MEP under xconnect PW, the Cisco 7609 send a SYSLOG message indicating a RDI defect alarm and the show ethernet cfm errors showed RDI defect too.
Aftert 18 seconds this alarm is cleared and the show ethernet cfm errors is empty.
I don't undestand this behaviour..why the Cisco send the RDI alarm in this situation?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...