Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Ethernet CFM

Hi folks,

Is there a way to relate the PortState referred to a remote MEP in CFM, to an action on the state of the port, instead of sending a trap?

I tried the cfm between three switches, and in the example the show of the remote MEP.

7600-tp#sh ethernet cfm maintenance-points remote

-------------------------------------------------------------------------------

MPID Level Mac Address Vlan PortState InGressPort Age(sec)

Service ID

-------------------------------------------------------------------------------

400* 4 001d.a28e.7e00 4 UP Gi4/19 4

service-vlan

Is there a way to put in shut the gi4/19 of the example, when the portstate is DOWN or ADMINDOWN?

Thanks.

642
Views
0
Helpful
0
Replies