Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ip sla configuration issues

Hi Guys;

i need some help configuring two way active management protocol on ME 3600x devices running 15.2.2 IOS. The details of this protocol are listed at:http://www.cisco.com/en/US/docs/ios-xml/ios/ipsla/configuration/15-2s/sla_twamp.html

Here i sthe sample configuration that i am using:

Device> enable
Device# configure terminal
Device(config)#  ip sla server twamp
Device(config-twamp-srvr)#  exit
Device(config)#  ip sla responder twamp
Device(config-twamp-ref)# end
My question is whether we "have to" configure the server and responder on the same device. I have configured it as:
ip sla responder
ip sla responder twamp
 timeout 300

And it does not seem to work.

Any help would be greatly appreciated!!!

cheers

2 REPLIES
New Member

I think some of these

I think some of these commands could help you:

 

show ip sla standards

show ip sla twamp connection

show ip sla twamp session

show ip sla twamp standards

, timer inactivity, timeout (twamp)..

Cisco Employee

Hello Jalalplease refer to

Hello Jalal

please refer to the CCO doc:

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/ipsla/configuration/xe-3s/sla-xe-3s-book/sla_twamp.html#GUID-1B9ED57D-44F8-49B7-81DE-94A49109F497

It mentions that "Each IP SLAs TWAMP responder is both a TWAMP server and a session-reflector." Thus the server and responder has to be configured on the same device. This is also mentioned in the same CCO doc shared above.

Hope this helps.

Vinit

Thanks
--VJ
712
Views
5
Helpful
2
Replies