Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ME3400 configuration

Hi,

we need to temporary setup the ME3400 switch to interconnect the two sites. Could somebody tell me how to configure the ME3400 based on the attached network diagram. I only have one unit of the ME3400 switch loan from cisco.

1 REPLY
New Member

Re: ME3400 configuration

!

system mtu 1546 ! Max for FE Interfaces

vlan dot1q tag native ! recommended for security

errdisable recovery cause l2ptguard ! if thresholds are set

!

interface

switchport access vlan

switchport mode dot1q-tunnel

l2protocol-tunnel

l2protocol-tunnel shutdown-threshold ! recomended for protection

l2protocol-tunnel drop-threshold !recommended for protection

!

Finally, if you set any of the port as Dot1q you must change the interface-type. This new in the ME series.

More details and configuration options are available at "Cisco ME 3400 Switch Software Configuration Guide"

http://www.cisco.com/univercd/cc/td/doc/product/metro/me3400/12244se/scg/index.htm

-W

267
Views
0
Helpful
1
Replies