I am new to metro ethernet and have two ME3600x switches. We are connecting multiple customers between to locations and I'd like to map them to different EVC's between the two metro switches at each location. I am attaching a diagram of a proposed architecture. can anyone assist/recommend a config. The link tothe SP network between ME3600's is a dedicated ME private line service. Thanks for any assistance.
I was able to get my metro switches configured and working properly but am having an issue accessing the MGMT port from my NMS station attached to CoreA. (see attached image). I can access the other switch OOB MGMT ports from the NMS attached to CoreA but not the metro. I can access the metro OOB MGMT port from CoreB. Any ideas?
The OOB vlan is trunked across the .1q link to the metro switch from the core switch. The Mac address of the OOB interface is not being dynamically learned on CoreA for some reason. I entered a static entry in the CoreA cam table, but I still can't access from my NMS. I have a TAC case open, but they've been unable to resolve.
Both cores are 6500's. I can access every other device on the OOB vlan from either side EXCEPT the metros. So, from the core a side I can't get to the b side metro. From the core b side, I can't get to the a side metro. I can get to everything else on the OOB vlan
This is an IOS bug wehre the metro is only checking the first 40 bits of the source mac, vs all 48, on ingress and dropping the frame since it is recognizing it as itself. cisco is releasing a new IOS version to fix this bug on 3/19/2012
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...