We have two sites connected by two equal cost Metro Ethernet circuits from two different service providers. we also have two redundant L3 core switches at both sites. What is the best way to connect these two sites for load balancing as well as redundancy? They are on different subnets. The core switches currently run HSRP. We also evaluating GLBP as a possible alternative.We want to possibly avoid all single points of failure.
You could, as you note, use GLBP, but an alternative could be, make the two paths from the intial/primary HSRP gateway appear equal cost. Many routing protocols would then alternate flows across the two paths.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...