Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Metro ethernet support

Hi all,

I have the folowing scenario:

Two 7604 conected back-to-back with a WS-X6148-GE-TX module. the vfi show up the ldp neigbhor show up but the on the vc detail i have :

Destination address: 2.2.2.2, VC ID: 100, VC status: up

Output interface: none, imposed label stack {21}

Preferred path: not configured

Default path: active

Next hop: Invalid ADDR

Also the show mpls forwarding :

N-PE1#show mpls forwarding-table

Local Outgoing Prefix Bytes Label Outgoing Next Hop

Label Label or VC or Tunnel Id Switched interface

19 No Label l2ckt(100) 0 none point2point

21 Pop Label 2.2.2.2/32 0 Gi4/2 10.10.10.2

Thus this configuration is supported on this module or is there samething else with the configuration ?

Many thanks

1 REPLY
Hall of Fame Super Silver

Re: Metro ethernet support

Hello,

it depends also how you have configured EoMPLS

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SX/configuration/guide/pfc3mpls.html#wp1318682

If I understand correctly if you used an SVI VLan you need a WAN interface.

Is interface g4/2 a port on module WS-X6148-GE-TX ?

you see there is a valid complete entry for 2.2.2.2/32 via g4/2

Hope to help

Giuseppe

263
Views
0
Helpful
1
Replies
CreatePlease to create content