Was going thro one of the document on METRO QOS and came across 2 commands "mls qos trust cos pass-through dscp" and second one is "no mls qos rewrite ip dscp ".Can any please elaborate these commands and share difference between them.
1.mls qos trust cos pass-through dscp -- To configure the multilayer switching (MLS) port trust state and to classify traffic by examining the class of service (CoS) or differentiated services code point (DSCP) value.
2.no mls qos rewrite ip dscp-- To enable type of service (ToS)-to-differentiated services code point (DSCP) rewrite, use the mls qos rewrite ip dscp command in global configuration mode. To disable ToS-to-DSCP rewrite, use the no form of this command
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
IntroductionIn this article we'll discuss how to troubleshoot packet
loss in the asr9000 and specifically understanding the NP drop counters,
what they mean and what you can do to mitigate them. This document will
be an ongoing effort to improve troublesh...