Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Per vlan or Per IP based Rate Shaping or Limiting using 6500s ? Possible?

Posted by: martin_tsang - Network Engineer, BigAir - Dec 1, 2005, 6:22pm PST

1. Is it possible to do per IP based rate shaping or rate-limiting in both directions?

2. Is this possible without some special card which costs heaps of $$$.

3. Is it possible to do per vlan rate shaping?

4. I have tried to look for help from cisco, but it seems to revolve around GTS.

Cisco Internetwork Operating System Software

IOS (tm) c6sup1_rp Software (c6sup1_rp-PSV-M), Version 12.1(22)E1, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Fri 16-Apr-04 10:13 by pwade

Image text-base: 0x60020F90, data-base: 0x616EA000

ROM: System Bootstrap, Version 12.0(3)XE, RELEASE SOFTWARE

BOOTLDR: MSFC Software (C6MSFC-BOOT-M), Version 12.1(3a)E4, EARLY DEPLOYMENT RELEASE SOFTWARE (fc1)

uptime is 1 year, 20 weeks, 6 days, 21 hours, 37 minutes

Time since xxxxxx switched to active is 1 year, 20 weeks, 6 days, 21 hours, 40 minutes

System returned to ROM by power-on (SP by reload)

System restarted at 14:23:56 AEST Thu Jul 8 2004

System image file is "slot0:c6sup11-psv-mz.121-22.E1"

cisco WS-C6506 (R5000) processor (revision 3.0) with 114688K/16384K bytes of memory.

Processor board ID TBA05290886

R5000 CPU at 200Mhz, Implementation 35, Rev 2.1

Last reset from power-on

X.25 software, Version 3.0.0.

Bridging software.

30 Virtual Ethernet/IEEE 802.3 interface(s)

48 FastEthernet/IEEE 802.3 interface(s)

2 Gigabit Ethernet/IEEE 802.3 interface(s)

381K bytes of non-volatile configuration memory.

4096K bytes of packet SRAM memory.

16384K bytes of Flash internal SIMM (Sector size 256K).

Configuration register is 0x2102

--------

Thanks in advance for any tips/hints/guides you may provide.

Cheers

martin

1 REPLY
Hall of Fame Super Silver

Re: Per vlan or Per IP based Rate Shaping or Limiting using 6500

Assuming you have a Sup-1a with PFC (or greater), you can use QoS policing. See the following reference for details:

http://www.cisco.com/en/US/partner/products/hw/switches/ps700/products_tech_note09186a00801c8c4b.shtml

One can apply policing on a per-VLAN or per-port basis.

137
Views
4
Helpful
1
Replies