Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Q-in-Q capability

Is there a capability to peel individual VID from each access tunnel port (with or without VID translation) and associate and stack it with a desired outer tag (with or without VID translation) for going upstream in the providers'network? For instance on the same ingress access tunnel port, there are VLAN 5, 6, 7, 8. We want VID 5 to be associated and stacked with VID 500 as the outer tag, VID 6 with VID 600 and so on. Where VID 500, 600 .... are provider's VID address space.

  • Metro
2 REPLIES
Silver

Re: Q-in-Q capability

I am not sure if this is possible, since the outer tag seems to be added based on the vlan to which the interface that receives the tagged packet belongs to and not on the tag in the packet itself.

New Member

Re: Q-in-Q capability

Could you recommend any vendor with such Q-in-Q capability on a CPE/CLE type equipment?

149
Views
0
Helpful
2
Replies
This widget could not be displayed.