Hi there
Network as shown:
Enduser -> eth-to-atm -> C7600 -> switch
The enduser uses FastEthernet and have several VLANs.
The "eth-to-atm" is a non-cisco based system capable of converting ethernet to atm cells and allowing baby giants (at least up to 1586 bytes).
C7600 with ATM STM-1 interface and GiEth.
Is it possible to create a connection between a PVC and a QinQ VLAN on the GiEth, so the switch on right receives a QinQ VLAN?
Anyone got an example?
