Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

qos on 6548blade

I need some help configuring QOS on a 6548 blade with sup720. I am a metroE subsriber on a port. I have a gig port speed with 100meg service. I have 25meg available for priority queue. I need to limit my aggregate output to 100meg. I need to mark priority traffic exceeding 25meg down before transmitting. The caveat that I am working with is the MetroE requires a 802.1q trunk so it looks as if the policies have to be configured on the vlan interface. It will not do a hiearchical policy as it will not accept the shape command in the parent policy. Can anyone shed some light on how I can get this accomplished?

1 REPLY
New Member

Re: qos on 6548blade

Hello, buddy.

If I got you right, you have a 7600/6500 with Sup720 equipped with 6548 module. In my opinion you are need a queuing mechanism to accomplish this scenario. Unfortunately there is no queuing on this blade, though. What you need is at least SIP200 with SPA interface.

Check the QoS table here. There is no Queuing mechanism. Only policing is available:

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps708/product_data_sheet09186a0080159856_ps4835_Products_Data_Sheet.html

Looking forward to hearing other peoples opinion.

Kind Regards,

Danail Petrov

176
Views
0
Helpful
1
Replies