I am having a heck of a time trying to configure rate-limiting on the 3400me switch for outgoing traffic. I basically have two ports that are facing the switch from a subscriber network and one on the service provider network.
port 1 -> subscriber
port 2 -> subscriber
port 4-> provider
There port 1,2 will be configured with a /30 ip address and a vlan will be passed in through port 4 from the provider network which is also a /30.
policer aggregate NWMNSA_DOWN cir 5120000 bc 960000 conform-action transmit exceed-action drop
class-map match-all WELLY match qos-group 5
policy-map NWMNSPA_DN class class-default police aggregate NWMNSA_DOWN
policy-map TEMP class WELLY shape average 5000000
policy-map MARKIT class class-default set qos-group 5
interface GigabitEthernet0/1 description Video no switchport ip address 10.10.10.245 255.255.255.252 load-interval 30 service-policy input MARKIT
interface GigabitEthernet0/2 description Video no switchport ip address 10.10.10.249 255.255.255.252 load-interval 30 service-policy input MARKIT
interface Vlan555 ip address 10.10.10.242 255.255.255.252
My Download or input policy takes action like I would expect. I have tried a ton of configuration choices to try and resolve this. The problems is I want to share 5Mb between g0/1 and g0/2 and not put input policies on them or rate limit at that point. On other vendors switches this is so simple. I can get this to work when i just use the interface as a uni in a similar manner, but the qos-groups must strip when they get routed through the switch. Basically I am trying to get 5Mb input and 5mb output when i use the switch. I do not want the total of 5Mb for upstream to be passed up my network and prefer to use the g0/4 to rate-limit the outgoing connection as a group if i can. I had it working earlier, but the qos-group function didn't apparently matter so I think I hit a bug.
The version I got it working as expected on is: Version 12.2(44)EY. The version that I had issues with was me340x-metroipaccessk9-tar.122-54.SE and -53. I have not looked through the bug reports on the issue but I may do that later. I thought I was doing something wrong all along.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...