i done various reseaches within cisco.com and came out a very simplified cmd to correctly perform L2 port-based rate limiting. However when applied into my test switch, i couldnt't see any counters/result captured for 'show polic-map interface'. Can someone advise if this setup is done correctly.
Unlike "router", for ordinary Catalyst switch (except ME series), you should apply "srr-queue" to rate limit the traffic on egress interface. If you really want "MQC" like setup, you should consider matching the flow (cef) the traffic instead of a class in the setup.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...