I'm looking for some guidance on how to configure a REP common link over VPLS. I've read a bunch of docs that more or less elude to the fact that it should be supported, but no combination of documents thus far have clearly outlined what the prerequisites are in terms of software, ES vs. ES+ hardware or relevant configuration glue to make this work.
Cisco Live 2010 session BRKSPG-2205 (Deploying and Designing with Resilient Ethernet Protocol) page 79
I've got two 7600/SUP720/SRE5 boxes with a chain of ME3400s connecting the two over 6724 LAN based linecard ports. I've also got an ES port between each 7600 to carry the SVI based EoMPLS foo between the two, and this is where I'd like to establish the VPLS common link (hopefully the below ASCII diagram will show up OK):
In terms of config, I've got the 6724 chain side configured as a REP segment and the REP admin VLAN is 1/default. I haven't been able to find the configuration glue needed to make REP aware that the common link for the segment is the VPLS pseudowire between the two 7600s:
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...