I am new in REP and my company is planning to have a ring with ME3800 Switches connected together to form a ring. This ring will be an access ring for my customers. At the edge switch, we have connected one port of the edge swith (port not in the rep segment) to our core switch (which is a normal Cisco 3560 Switch) through a normal STP trunk.
When i connect the ring to the 3560 Switch (to connect the ring to the core, using a trunk port), i see the port where it is connected blinks very fast which leads me to think that it may be a loop.
I have put my design in the attached file and hope you'll help me to understand.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...