An enterprise has 6 sites connected to each other via private point-to-point DS3's in a ring topology. No SONET, straight DS3. (see attachment)
Is it possible to run RPR over DS3? If yes, can the ONS-15310-CL do this? I see the 15310 has three DS3 interfaces, but the documentation I've pulled up looks like RPR has to run on the expansion card.
Idealy RPR would run over the DS3 interfaces and the expansion slot would be the ML-100T-8, which would be 802.1q tunnel interfaces.
Am I way off here? I admit I don't know what I'm talking about, but this could end up being a very flexible solution for my company.
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...