Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

STM-1 PVC mapping

i have STM-1 card STM-1 Port Adapter (PA-MC-STM-1) on router cisco 7206 & i need to divide it according to the following:

1-one PVC that carry 40Mbps net(without framing).

2-another PVC that carry 40Mbps net(without framing).

3-the third PVC will carry the remaining BW of the STM-1

Note:when searching in the configuration guide i found that :

RTR(config-controller)#aug mapping au-3

& au-3 contain 21 TU-12s each with 2Mbps

so the net is 42 Mbps , which i neeed,but is the 42Mbps is net traffic(i mean is this without header?)because i need 40Mbps net,so could any one provide me a sample configuration of the scenario needed?

1 REPLY
Silver

Re: STM-1 PVC mapping

The traffic will be the traffic sent across the link and not the traffic without header. Following link may help you

http://www.cisco.com/en/US/docs/ios/12_4/wan/configuration/guide/h_frbnd.html

189
Views
0
Helpful
1
Replies