Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

6PE unspecified route question

does anyone know why an unspecified route originated via a neighbor default-originate command in a 6PE environment does not have a label sent along with it?

no label makes it unusable in the 6PE environment as the receiving router sees the prefix as inaccessible, so is this a bug or am i missing something?

see the comparison of an unspecified prefix and gloabl unicast advertised over a 6PE session

thnaks

*Mar  1 00:21:16.295: BGP(1): 1.1.1.1 rcvd UPDATE w/ attr: nexthop ::FFFF:1.1.1.1, origin i, localpref 100, metric 0
*Mar  1 00:21:16.303: BGP(1): 1.1.1.1 rcvd ::/0


*Mar  1 00:21:16.335: BGP(1): 1.1.1.1 rcvd UPDATE w/ attr: nexthop ::FFFF:1.1.1.1, origin i, localpref 100, metric 0, path 2
*Mar  1 00:21:16.339: BGP(1): 1.1.1.1 rcvd 2002::/16


*Mar  1 00:21:16.351: BGP(1): no valid path for ::/0
*Mar  1 00:21:16.355: BGP(1): nettable_walker ::/0 no best path


*Mar  1 00:21:16.363: BGP(1): Revise route installing 2002::/16 -> ::FFFF:1.1.1.1 (::) to main IPv6 table

PE2#sh ip bgp ipv6 uni ::/0
BGP routing table entry for ::/0, version 2
Paths: (1 available, no best path)
  Not advertised to any peer
  Local
    ::FFFF:1.1.1.1 (inaccessible) from 1.1.1.1 (1.1.1.1)
      Origin IGP, metric 0, localpref 100, valid, internal


PE2#sh ip bgp ipv6 uni 2002::/16
BGP routing table entry for 2002::/16, version 4
Paths: (1 available, best #1, table Global-IPv6-Table)
  Advertised to update-groups:
     1
  2
    ::FFFF:1.1.1.1 (metric 3) from 1.1.1.1 (1.1.1.1)
      Origin IGP, metric 0, localpref 100, valid, internal, best
      mpls labels in/out nolabel/20

1 REPLY
Hall of Fame Super Silver

Re: 6PE unspecified route question

Hello Dean,

in ipv4 we need a command to associate a label to a default route ( I know for LDP binding)

http://www.cisco.com/en/US/docs/ios/mpls/command/reference/mp_m1.html#wp1013700

mpls ip default-route

I don't know if an mpls ipv6 default-route command exists, but a default route is a special case.

if you are using IPv4 addresses mapped in IPv6 I would try to enable the above command.

Hope to help

Giuseppe

469
Views
0
Helpful
1
Replies