I'm running into a problem with a 7507 router running 12.4 where any vlan subinterfaces inside a VRF is being process switched instead of CEF or fast switched. I've verified that the source and destination addresses are valid in the cef FIB but for some reason it's falling back to process switching. Any ideas?
I've attached the config and the output of all the show commands I can think would be related.
For a test instance, packets from source 10.1.25.5 traveling to 126.96.36.199 are process switched, as are packets from 192.168.0.35 to 10.1.27.42.
I'm running the newest 12.4(13b). According to bugtracker it looks like it's supposed to be fixed in 12.4(7.17)T and 12.4(7.17)M, is my understanding correct that the 12.4M fixes would be incorporated into 12.4 mainline?
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application Engineered...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?
Cisco Software Manager Server
This document describes the programmatic interfaces, RESTful APIs, which are supported by Cisco Software Manager Server (CSM Server).
CSM Server supports a set of finite RESTful APIs. The fir...