I tried to configure the cisco router 2811 replacing the HUAWEI router with the below config details i usally do for the adsl connection usign SDM GUI.
The PVC 8/35 and encap pppoAMUX and username and password.
But the result is atm up but the virtual-access 2 is down. LCP ReQ some message appear.
Finally the ISP informed us that they setup would not support Cisco routers and adviced the customer go for fixed ip adsl service that support the config i used (PVC,PPPOAMUX). ISP gave the customer managed adsl service that not work with cisco router. I do not believe it and i believe i forget the cmds to configure.
So i came to the Form for your help.
Please advice me how can i support the customer?.
Customer adviced by ISP for the leased line service with fixed IP ADDRESSES.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?