I am configuring aggregate policing policers on a 3750 switch so our customers can use different access speeds. I'm unsure, however, what to set the burst to. The bandwidth access speeds i am looking to set up are for 10, 20, 30, and 40Mbs, thanks Ian
The burst size is typically set to 1/8 th of the CIR ( or Minimum CIR ) which you contract with the customer as SLA. The Tc , the committed time which allows to burst to this value defaults to 200ms (Platform dependent ).
This document is an early notification of a behaviour change that will be introduced in IOS XR release 6.5.
IOS XR configuration principles relevant for this article are:
On router platforms all interfaces must be by defaul...
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application ...