Please take a look at the diagram which depicts a lab I set up in order to get this technology working for a production network. As you can see from the diagram the test set is sending 5,000 Cells/sec and those cells are sent 100% throughout the network until it reaches the 7609 where the cells are received just fine on the gigabit interface that connects to the previous router. But there seems to be a problem after that. I'm wondering what I am doing wrong. I am including the pertinent router configs as well.
If I take the 7609 out of the equation and connect the M10 directly to the ATM switch the 5,000 Cells/sec are received just fine.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...