The PE are operator M320 Juniper routers the CE are our 7609 routers with SUP 720 and SIP-200 where the ATM is connected. The operator provides us only with IP connection to his routers and does not accept our routers to be configured as PE. To configure ATM over MPLS I need my routers to be PE. My questions are:
1. Is 7609 support MPLS over GRE (or any other type of tunnel) and do you need any additional hardware?
2. Is anyone have some example of such type of configuration?
If alternatively you plan to run GRE between you 76k and then run MPLS over it, then also its fine, as you have labels for both the IGP path (Using GRE and enabling MPLS on it) and using directed LDP you have labels exchanged for the VC's as well. But to do this confirm with your local SE about the support for Tag-Switching for GRE on 76K.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...