Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ATM VP switching over MPLS

hi,

is it possible to do VP switching for AToM ?

ie:

R1---PVC1/200-----MPLS-----PVC2/200--R2

8 REPLIES

Re: ATM VP switching over MPLS

I believe you are trying to do VP Mode ATOM.

The below link has information on how to configure the same.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1829/products_feature_guide09186a008016102a.html#wp1271181

But this has platform dependencies I believe. Like in 7600 you will need a SIP/SPA, and in 7200 it works but i believe its single cell relay, just check on these features part as to what is your requirement when you implement VP mode.

HTH-Cheers,

Swaroop

New Member

Re: ATM VP switching over MPLS

thanks for the info.

did you have any real network configuration sample?

Re: ATM VP switching over MPLS

I dont have a real config.

HTH-Cheers,

Swaroop

New Member

Re: ATM VP switching over MPLS

let say i have the following setup, pls verify if my configuration is correct..

pvc2/200---PE1======PE2----pvc1/200

PE1:

interface atm0/0

atm pvp 2 l2transport

xconnect 10.0.0.2 123 encapsulation mpls

PE2:

interface atm0/0

atm pvp 1 l2transport

xconnect 10.0.0.1 123 encapsulation mpls

Re: ATM VP switching over MPLS

Yes this config should cross connect your VP in port mode.

Which devices you are using in your lab and do you have the access to the lab to test it out.

HTH-Cheers,

Swaroop

New Member

Re: ATM VP switching over MPLS

i do not have access to the lab.

but, i will need to implement it on 12000

so, for VP mode cell relay, i do not need to configure VCI ?

Re: ATM VP switching over MPLS

In VP Port Mode you will do a NNI type of interconnect between the Edge ATM Switches, who would to the multiplexing of VC's over this VPI.

HTH-Cheers,

Swaroop

New Member

Re: ATM VP switching over MPLS

I think there are some misunderstanding. let me clarify my setup:

Equip1(pvc1/200)---PE1(Eth)---MPLS---(Eth)PE2---(pvc2/200)Equip2

I have 2 equipments, both need to communicate in ATM.

VPI1 from Equip1 need to switch to VPI2 in Equip2 and vice versa

188
Views
3
Helpful
8
Replies