Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
Silver

ATOM LFIB Inconsistency

HI,

When configuring L2 VPN over MPLS, I have noticed in some text documentation, MPLS config in Cisco IOS, that when viewing the LFIB via “show mpls forwarding-table” the L2VPN circuit details will show “none” as the outgoing interface, whereas in other text, “L2VPN VPN Architecture” the same command will show the actual CE outgoing interface when viewing the LFIB.

I have tested this on dynamips, and it also did not show the outgoing interface, but passed the traffic correctly.

Can anyone advise on why there are differences when viewing the LFIB as far as L2VPN are concerned?

Is this hardware or software relevant?

Thanks very much.

LR

1 REPLY
Silver

Re: ATOM LFIB Inconsistency

hi!

It could be due to different software. I am able to see the details when using 6500 SXH release train...

6506-Himgiri#sh mpls forwarding-table | i 873

873 No Label l2ckt(201) 0 Gi6/1.701 point2point

Regards,

Niranjan

134
Views
0
Helpful
1
Replies
CreatePlease to create content