Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Basic MPLS configuration

Hi

I have a basic mpls configuration between my two PE routers in a lab environment, but I can't see my ldp neighbor. below are my configs for one side, but the other side is configured exactly like this side.

CR7613PE# sh mpls ldp neighbor

CR7613PE#

CR7613PE#sh mpls ldp discovery

Local LDP Identifier:

192.0.0.1:0

Discovery Sources:

Interfaces:

POS1/1/0 (ldp): xmit/recv

LDP Id: 192.0.0.2:0; no route

ATM1/0/0.100 (ldp): xmit/recv

LDP Id: 192.0.0.2:0; no route

!

interface ATM1/0/0.100 point-to-point

ip address 192.100.1.1 255.255.255.252

ip router isis

no atm enable-ilmi-trap

mpls label protocol ldp

mpls ip

pvc 0/101

encapsulation aal5snap

!

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Basic MPLS configuration

Hi

Is-Is is fine but these route-ids are not advertised in it. Try to ping the remote ldp router id.

regards

shivlu jain

3 REPLIES
Silver

Re: Basic MPLS configuration

the ldp router id is showing 192.0.0.2 which is not advertised in IGP. Advertise it in IGP , then see the results.

regards

shivlu jain

New Member

Re: Basic MPLS configuration

I have is-is configured between these two routers, do you mean I must have another routing protocol between these two routers?

Silver

Re: Basic MPLS configuration

Hi

Is-Is is fine but these route-ids are not advertised in it. Try to ping the remote ldp router id.

regards

shivlu jain

167
Views
5
Helpful
3
Replies
CreatePlease login to create content