MPLS

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hey guys, I got a problem.In the picture attached, R1 & R4 are running iBGP with 192.168.12.1, 192.168.34.4 and "next-hop-self" eabled. Now R6 wants to ping 5.5.5.5 which is R5's loopback0, and I know it would fail. Because the next-hop of 5.5.5.5 is...

Hello, I am trying to understand the use of 'mpls ldp password required' command.  If I configure just the 'fallback' command but not the 'required' command ldp authentication still works. then what is the use of the 'required' command? Thanks,Sachin

can we build IPSEC between C9300 and Cisco ASR 1002? if not, any other options to configure data encryption with these hardware models using the mpls provider.

I'm trying to configure mVPN Profile 6.I am following a Cisco Live Lab by the letter and when I get to this stage:     RP/0/0/CPU0:PE1#conf t RP/0/0/CPU0:PE1(config)#route-policy vrf-one-profile-6 RP/0/0/CPU0:PE1(config-rpl)#set core-tree mldp-inban...

HelloI know well if we have several paths to the destination, we will BGP Best Path Selection Algorithm  . my question ,in which case we were obliged to use :  BGP Best Path Selection Algorithm   and  and don't use anything else ?? i wait a answer fr...

I'mseeing overflow of alerts on the 9K switch. Temperature looks good, Power status looks good, no operational impact was reported so far. Not much information found on the ciscobug website(https://bst.cisco.com/quickview/bug/CSCuv68250). However, th...

Dear ,I’m trying to configure INTER-AS VPLS as the attached topology the ASBR1:Cisco IOS , PE1:ASR9K and ASBR2:Juniper MXThe L2vpn BGP Multi-hope BGP is up and I can see the label swapping form the both end but the VC is down RP/0/RSP0/CPU0:IGW-LON-1...

1. PPPoE Session on CE1:CE1#SHOW PPPOE SESSION1 client sessionUniq ID PPPoE RemMAC Port VT VA StateSID LocMAC VA-stN/A 0 0000.0000.0000 Fa0/0 Di1 N/A PADISNT0000.0000.0000```2. Interfaces on CE1:CE1#SHOW IP INT BRIInterface IP-Address OK? Method Stat...

Capture.PNG

2 つの RR ルーター間で VPNV4 ネイバーを確立する際のトラブル この問題の解決を手伝っていただければ幸いです。 ありがとうRP/0/0/CPU0:P1-RR#show bgp vpnv4 unicast summaryTue Dec 5 11:26:33.927 UTCBGP router identifier 172.16.1.3, local AS number 100BGP generic scan interval 60 secsNon-stop routing is enab...

YangLi_0-1701825529196.png
Yang Li by Level 1
  • 879 Views
  • 9 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Unanswered Topics