Now coming to the problem, I have two CE router connected to the same PE router and both are in same vrf (vrf-a), I have configured the routing in such a way that spoke to spoke traffic goes via HUB however with the above scenario its now working as both CE's are connected to the same vrf and when the packet reaches vrf-a , its sees that the destination is directly connected or in case if it’s not directly connected , still it prefers spoke to spoke (Shortest As –path is the tie).
Is there any way I can make spoke to spoke communication via HUB?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...