Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Catalyst 8510 MSR as PE?

Hi there

In order to prolong the life of some of our old Cat8510MSR, I was wondering whether the could be used for PEs in a MPLS network.

The switch is equiped with ATM router module (not the enhanced) and standard RAM config.

We are going to replace these switches with 7600s, but until this happens, it could be quite good to reuse these switches in the smaller parts of the network.

1 REPLY
Purple

Re: Catalyst 8510 MSR as PE?

Hi,

According to:

http://www.cisco.com/en/US/customer/products/hw/switches/ps718/products_configuration_guide_chapter09186a008047b9d3.html#wp1066738

you required the Enhanced ATM ROuter Module to support MPLS on the 8510MSR.

Hope that helps - pls rate the post if it does.

Paresh

163
Views
0
Helpful
1
Replies
CreatePlease login to create content