Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CE to PE OSPF

Hi there,

Normally, at PE, the route of particular VRF is shown as a BGP.I would like to know, it is a normal when there is an OSPF route like below example:

PE#sh ip route vrf vrf1

Routing Table: vrf1

Gateway of last resort is not set

192.168.1.0/32 is subnetted, 1 subnets

O 192.168.1.1 [110/11] via 200.0.0.106, 00:05:15, FastEthernet1/0

192.168.2.0/32 is subnetted, 1 subnets

B 192.168.2.1 [200/11] via 200.0.0.10, 03:42:13

200.0.0.0/30 is subnetted, 2 subnets

B 200.0.0.112 [200/0] via 200.0.0.10, 05:48:31

C 200.0.0.104 is directly connected, FastEthernet1/0

Thanks in advance.

maher

2 REPLIES
Bronze

Re: CE to PE OSPF

It is absolutely fine. All that has been done here is that the peering between CE and PE is done using OSPF. Perfectly normal and perfectly acceptable.

New Member

Re: CE to PE OSPF

Thanks for the info.Just curious about OSPF leak into global routing table..just to make sure, whether a correct configuration.

thanks again.

maher

192
Views
0
Helpful
2
Replies
CreatePlease to create content