Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CE to PE static configuration

Hi there,

I'm having problem to assign a static route to my CE.Below is the message:

PE(config)#ip route vrf vrf1 192.168.2.0 255.255.255.0 FastEthernet 0/0

% For VPN routes, must specify a next hop IP address if not a point-to-point interface

If I change to serial interface, there is no message appear.Can I assign on any FE for static route?FYI, FE and Serial inteface are connected to CE.

thank you.

maher

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: CE to PE static configuration

You should have no problem configuring:

"ip route vrf vrf1 192.168.2.0 255.255.255.0 FastEthernet 0/0 x.x.x.x" with X being your next hop IP

3 REPLIES
New Member

Re: CE to PE static configuration

You should have no problem configuring:

"ip route vrf vrf1 192.168.2.0 255.255.255.0 FastEthernet 0/0 x.x.x.x" with X being your next hop IP

New Member

Re: CE to PE static configuration

Hi there,

Thanks, it really work!

maher

New Member

Re: CE to PE static configuration

No problem. Good luck !

161
Views
0
Helpful
3
Replies