In the diagram i have 2 sites. In site 1 i have 2 PE devices with Vlan 3,33 in VTP database and couple of servers in both vlans. Need to extend both vlans broadcast domain to site 2 access layer switches. MPLS/LDP enable on PE's. I am assuming that without another access layer attached to PE3/PE4 with a tunk interface i cannot enable psedowire on PE3/PE3! since i need an (L3 - without an ip address) interface to enable xconnect on. Will vlan-base psedowire work? but will need a SIP card on the PE's since they are 6509!!
Any comment? Let me know you need more clarification..
You're right. You need a SIP card for your uplinks if you want to apply the xconnect to an SVI interface.
You could try creating a trunk for VLAN 3 and 33 between PE3 and PE4. Assuming all the servers are connected to PE3 (there are 2x PE3 on your drawing ;-) ), you could apply the xconnect on PE4 trunk interface only to PE1 as primary and PE2 as secondary:
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on Application Engineered...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?
Cisco Software Manager Server
This document describes the programmatic interfaces, RESTful APIs, which are supported by Cisco Software Manager Server (CSM Server).
CSM Server supports a set of finite RESTful APIs. The fir...