how to configure a L3 MPLS VPN over which DHCP should get accessed. I have created L3 MPLS VPN between 2 locations. In locaton "A" DHCP server is located and at Location "B" DHCP client is located. As per the requirement client host should get the ip address from the DHCP server.
I configured the PE router which is at client side as DHCP Relay agent but no result. the main problem is i don't know the trouble shooting commands using which i can come to know where the problem is exactly.
I don't have proper material also for the entire configuration and trouble shooting....
if any body have the configuration plz provide me....
Ok. So were you able to troubleshoot as per my earlier post to see at which point it is failing. Whether the request is sent to the server, whether the server is responding and if the response is getting dropped, the ip addresses in the request response... if they are as expected?
Introduction: The "external-out enable" command is available for
configuration under the "router ospf process" in case of the IOS-XR
operating system. This command basically enables advertisement of
intra-area routes on the device as external routes in th...
Introduction Basic configuration for netflow Scale parameters for
netflow Netflow support Architecture Packet flow for netflow Inside the
LC CPU Netflow Cache size, maintenance and memory Sample usage Cache
Size Aging Permanent cache Characteristics Which...