01-16-2007 09:29 AM
Configured a subinterface in Gig ethernet with /30 mask but still its observed that in routing table it entry is /32.
Platform is 7206 NPE-G with MPLS enabled
01-16-2007 11:55 PM
Hi,
can you please give more information like a relevant portion of the config and show command outputs?
In some environments host routes are created by routing protocols.
Regards, Martin
01-27-2007 01:47 AM
Foll is sample config in which connected /30 route is seen without any subnet in "show ip route" output
ip vrf TEST
rd AS:12422
route-target both AS:10396
ip vrf forwarding TEST
ip address 172.25.240.253 255.255.255.252
address-family ipv4 vrf TEST
redistribute connected
redistribute static
no auto-summary
no synchronization
exit-address-family
sh ip route vrf TEST connected
C 172.25.240.252 is directly connected, FastEthernet 0/1.1212
01-28-2007 11:36 PM
Hi Vinayak,
The sh ip route vrf output seems to be correct.
The ip address configured on the inerface is 172.25.240.253/30 which falls within the subnet 172.25.240.252.
This subnet entry is correctly being shown as directly connected.
HTH, rate if it does
Narayan
01-29-2007 01:01 AM
If its connected route is should be in routing table with subnet/30 and not /32 as seen currently .
01-29-2007 02:07 AM
Vinayak,
Can you please issue the command sh ip route vrf test without the connected keyword and check.
Post the results
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: