Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Disabling split horizon for H-VPLS on 7609

Hi,

We installed a new 7609 in our lab for doing H-VPLS interop. The sw Version is IOS (tm) s72033_rp Software (s72033_rp-PSV-M), Version 12.2(18)SXD7.

I do not see the "no-split-horizon" option when trying to configure the remote spoke PE.

l2 vfi PE3-VPLS-A manual

vpn id 200

neighbor 20.0.0.1 encapsulation mpls <no-split-horizon>

Is there a version problem or some config issue ?

Thanks

AT

4 REPLIES
New Member

Re: Disabling split horizon for H-VPLS on 7609

The hw info is as follows :-

Mod Ports Card Type Model Serial No.

--- ----- -------------------------------------- ------------------ -----------

1 2 2+4 port GE-WAN OSM-2+4GE-WAN+ JAB0847061N

5 2 Supervisor Engine 720 (Active) WS-SUP720-BASE SAL0919113H

Mod Sub-Module Model Serial Hw Status

--- --------------------------- ------------------ ------------ ------- -------

5 Policy Feature Card 3 WS-F6K-PFC3BXL SAL09253GNF 1.6 Ok

5 MSFC3 Daughterboard WS-SUP720 SAL09190TCD 2.5 Ok

Cisco Employee

Re: Disabling split horizon for H-VPLS on 7609

This option was introduced in 12.2(18)SXE and is therefore not present in the version you are currently running.

Hope this helps,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: Disabling split horizon for H-VPLS on 7609

I loaded 12.2(18)SXF4, and the option is there now.

Thank you!

New Member

Re: Disabling split horizon for H-VPLS on 7609

Hi,

We have the following card installed in the Cisco 7609 :-

OSM-2+4GE-WAN

I do not see the "switchport" commands on the 4 WAN ports ? Is this normal ? How do I enable VLANs plus STP on the 4 WAN ports ?

I only see the "switchport" commands on the first 2 LAN ports.

IOS 12.2(18)SXF4

Thanks

925
Views
5
Helpful
4
Replies
CreatePlease to create content