Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

display the mpls lable stack

Hello

below topology:

ce1-pe1-p1-p2-p3-p4-p5-pe2-ce2

ce1 and ce2 are two vpn sites under same vrf.I set up MPLS TE tunnel between p2 and p4,so the traffic from ce1 to ce2 shall use this traffic when in the mpls cloud.In theory,I shall see three labels in the label stack on p4.How can verify it? Thank s in advance.

1 REPLY
New Member

Re: display the mpls lable stack

If you look in the CEF table for the VRF the VPN plus the TE lable are indicated. The MPLS lable should be checked in the MPLS forwarding table.

Command is : show ip cef vrf prefix. Then you will see a line with tags imposed which indicate two lables.

Hope this helps.

-Ives-

189
Views
0
Helpful
1
Replies
CreatePlease login to create content