Dear all
I am looking at a project that would involve migrating Ethernet traffic off a L2 network ( V Large) onto an MPLS network and I am looking to support the following configuration:
A customer has a firewall connected via Dot1Q to a PE. Can I configure one VC from that PE to a remote PE and have that PE also terminate on a Dot1Q configured port. Also the customer would need to have a connection to an other remote device that is connected via port mode.
Is it possible for the customer attachment port ( running dot1Q) to connect to both Dot1q and port mode endpoints
Any help greatly appreciated
Regards
John Keane