Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EoMPLS fail

Hi,

I am setting up EoMPLS (AToM) in my lab. Topology is simple, just have 2 Cat6509 (with native IOS) connect back-to-back. These 2 Catalyst act as PE. On each catalyst, there is one catalyst acting as host (CE). I am configuring 'mpls l2transport' under interface vlan, instead of subinterface. It is weird when i found that under subinterface, there is no command 'mpls l2transport' nor 'xconnect'. Both command is available only under interfce vlan and L3 interface.

You all can check my configuration. Thanks fr every response.

5 REPLIES
Cisco Employee

Re: EoMPLS fail

Change the netmask of the loopback address on R1 to /32 instead of /24.

Also "mpls ip" doesn't need to be configured on interface vlan23.

Hope this helps,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: EoMPLS fail

Hello

Please do the configuration on physical interface except over Vlan

interface GigabitEthernet1/45

mpls l2transport route 1.1.1.1 100

no ip address

end

What is superviser engine on 6500

Cisco Employee

Re: EoMPLS fail

Could you also attach a "show mpls l2transport vc detail" from R2.

Thanks,

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: EoMPLS fail

Hi,

EoMPLS is not supported on Layer 3 VLAN interfaces for C6500/7600.

If you need to configure EoMPLS on the SVI the core-facing card must be an OSM.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/122sx/swcg/pfc3mpls.htm#wp1279824

Kind regards,

Dmitriy.

New Member

Re: EoMPLS fail

HI Dmitriy

EoMPLS is supported on 6500 and 7609 if you have sup7203b or sup7203bxl cards.

you need OCM base cards for VPLS

well can you attache sh tech file here...

Kind regards

Zeeshan Nadeem

215
Views
0
Helpful
5
Replies