Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Error while applying the Service Policy

Hi,

I am getting the below error while applying the service policy to the Interface.

I have set the mpls exp 4 as well as want to limit the bandwidth to 1Mbps

PE#sh policy-map setexp-GBoIP

  Policy Map setexp-GBoIP

    Class GBoIP-traffic

      set mpls experimental imposition 4

     police cir 1024000 bc 32000

       conform-action transmit

       exceed-action drop

PE(config-if)#int vlan 2007

PE(config-if)#service-policy input setexp-GBoIP

QoS-ERROR: Addition/Modification made to policymap setexp-GBoIP and class GBoIP-traffic is not valid, command is rejected

As well as I have created new clas--map with priority and Bandwidth and applied in output direction, I got the belwo error while applying the Service policy in

PE(config-if)#service-policy out TEST

bandwidth command is not supported in output direction for this interface

PE(config-if)#service-policy output TEST

priority command is not supported in output direction for this interface

Any idea why so ?

Thanks in Advance.

Regards,

Nilesh

398
Views
0
Helpful
0
Replies
CreatePlease to create content