yesterday I faced a weird issue in 7200 router. It was configured as LNS using its loopback for radius authnetication. But when I checked the logs on radius it is getting the physical interface ip. After that I configured my source as physical interface authentication process completed.
Can anyone tell me why it is not getting source as loopback. On other routers it is working fine.
Glad it is now working. I think it could be related to CSCsq32625, which is a duplicate of CSCse02550, which was indeed fixed in 12.2(31)S13.
ip radius source-int not working inside aaa group server config
Symptom: Only Global setting for the AAA Radius server source interface is functioning. Setting the source-interface in the AAA Group configuration has no effect. Conditions: This condition is visible when a router must use more than one source-interface designation for communicating with the RADIUS servers serving it. For example, if there are two groups of servers, and one group uses a Loopback for the source interface, and second group uses the management FastEthernet interface as the source interface. Workaround: All radius servers need to be able to respond to a single source interface, as multiple sources distinguished by AAA Groups are not functioning. Further Problem Description: None
Harold Ritter Sr. Technical Leader CCIE 4168 (R&S, SP) email@example.com México móvil: +52 1 55 8312 4915 Cisco México Paseo de la Reforma 222 Piso 19 Cuauhtémoc, Juárez Ciudad de México, 06600 México
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...