12-05-2005 02:49 PM
Hi!
I'm trying to set up a FRoMPLS connection between a Cisco and a Juniper router. The same config. works fine between Ciscos.
The mpls l2transport vc is not working.
12-05-2005 05:57 PM
Why is the LDP session to the j4300 seen as 10.15.10.231 if the loopback address is 10.15.10.246 In the configuration.
Hope this helps,
12-06-2005 10:15 AM
12-06-2005 01:42 PM
The CW is find. The Martini draft specifies that the CW is required but that its use is optional. It the case it is not used it has to be set to 0, which is the case here.
So what doesn't work now. You can't pass traffic from one CE to the other?
12-06-2005 02:30 PM
Do you see the PVCs as up on both CEs?
Thanks,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: