Get the attribute_flags of the interface

[jdavid_t]

Hi all,

Does anybody know how to get the value of the attribute_flags of a physical interface over which a MPLS Tunnel could traverse if the affinity bits are conformed?

I mean, when we configure with the next CLI command

Router(config-if)#mpls traffic-eng attribute-flags

the attribute-flags of an interface, that it will be later check to conform with the affinity configuration of the tunnel, How can I get the value of attribute-flags by querying a MIB? Which MIB?

Thanks to all.

Joan.

[mheusinger]

Hi,

my best bet would be 1.3.6.1.4.1.9.10.99, which is about OSPF opaque LSAs, they contain the relevant information. There is no MIB variable especially for the affinity bits on an interface as far as I know.

Hope this helps

Martin

Link: http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?local=en&translate=Translate&objectInput=1.3.6.1.4.1.9.10.99