GRT to VRF

[nedian123]

Hi,

I am stuck in enabling communication between GRT & VRF in 7609. I have tried following thing but no success & I am stuck in a project migration b/c of this. Any feedback would be appreciated.

RouterA:

int vlan10

ip add 1.1.1.1 255.255.255.0

int vlan 100

ip vrf forwarding CUST

ip add 2.2.2.2 255.255.255.0

ip route 2.2.2.2 255.255.255.255 vlan100

ip route vrf CUST 1.1.1.1 255.255.255.255 vlan10

arp 2.2.2.2 aa11.bb11.cc11 arpa

arp vrf SHARED 1.1.1.1 aa22.bb22.cc22 arpa

RouterA:

ping 2.2.2.2 source 1.1.1.1 (timeouts)

ping 1.1.1.1 source 2.2.2.2 (timeouts)

Regards,

Akhtar

[Reza Sharifi]

you need to point your static route to the loopback address of the GRT and also to your vrf loopback address:

ip route 2.2.2.0 255.255.255.0 Loopback0 1.1.1.1

in the above static route loopback0 is the GRT loopback and 1.1.1.1 is the VRF loopback address.

This is how I got mine working

HTH

Reza

[Reza Sharifi]

you need to point your static route to the loopback address of the GRT and also to your vrf loopback address:

ip route 2.2.2.0 255.255.255.0 Loopback0 1.1.1.1

in the above static route loopback0 is the GRT loopback and 1.1.1.1 is the VRF loopback address.

This is how I got mine working

HTH

Reza

[nedian123]

Hi reza,

Thanks for your feedback. But its not working still. Can you paste your configs & output(with arp & vrf arp)

Regards,

Akhtar

[Reza Sharifi]

Akhtar,

I did not configure arp or vrf arp.

I posted a similar question on the 15th of this month. Go ahead and check it out to see if it helps you in resolving this.

I also atteched my config in that post

HTH

Reza