Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How do I force a Interface/XConnect up?

Hello,

I'm currently deploying some ISR 1900 as MPLS hand off with xconnect and would like to do testing to make sure that the configuration is correct, but I can not find a way to force my customer facing interface in a up state without them plugging something in.

Se below for configuration

#sh xconnect  all

Legend:    XC ST=Xconnect State  S1=Segment1 State  S2=Segment2 State

  UP=Up       DN=Down            AD=Admin Down      IA=Inactive

  SB=Standby  RV=Recovering      NH=No Hardware

XC ST  Segment 1                         S1 Segment 2                         S2

------+---------------------------------+--+---------------------------------+--

DN     ac   Gi0/1(Ethernet)              DN mpls x.x.x.x:10000          DN

interface GigabitEthernet0/1

description "Customer interface"

no ip address

duplex auto

speed auto

xconnect x.x.x.x 10000 pw-class ETH-PW

end

And I would like to force it up so I can verify that configuration and that the eompls is working?

I tried the "loopback mac/driver" command under interface, but saw no reaction from the box.

Software version: c1900-universalk9-mz.SPA.151-4.M4.bin

Everyone's tags (4)
682
Views
0
Helpful
0
Replies
CreatePlease to create content