I am studying MPLS. And in my book it just said in order to enable MPLS in the ATM switch for running cell mode, use "mpls ip" command in the interface mode is ok. But when I tried it no LS1010, and when I added the command, it said that no control-vci is available on that interface. Can anybody help me? Is the command "ip cef"command needed in ATM switch? I think the command is not needed.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...