Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How to verify ATM MPLS neighbor?

Hi All,

How to verify ATM MPLS neighbor?After I config MPLS in my ATM client and switch. when I use show mpls ldp neighbor and show mpls ldp discovery, I can not see the LS1010 ATM switch as my neighbor. But I can see the other side of the ATM client is my neighbor. Is there anything wrong? Thank you!

Best Regards

Teru Lei

2 REPLIES
Bronze

Re: How to verify ATM MPLS neighbor?

Check this document http://www.cisco.com/en/US/tech/tk436/tk798/technologies_tech_note09186a0080093c97.shtml for a sample output of show tag tdp neighbor command. See if you could match it with yours.

New Member

Re: How to verify ATM MPLS neighbor?

Thank you for your reply. So I think my status is correct. I should not see the ATM switch as my tdp neighbor. I think my config is working because I can see the VC as the MPLS tag. But I still can not 100% confirm.

137
Views
0
Helpful
2
Replies